When you bought a Motion car, you were going all-out. Nobody in the supercar game was doing what Motion Performance was doing. Motion cherry-picked the best factory parts, added the best aftermarket parts, then dyno tuned each car to make sure that when it was delivered to the customer, it was at the very peak of its game.
The flipside of that deal is it took some pretty serious money to buy a turnkey Motion car. They were genuine exotics and had the price tag to match. The Motion customer had to swing not only a new Corvette, but also the price of Motion's conversion and the killer insurance premiums to keep it registered. Not everyone could pull off such a deal.
Motor: This 427 still screams!
Another way to tap into the Motion mystique was to go through their catalogs and roll-your-own Motion Corvette. This made more sense to guys with limited funds. They could Motion-ize their ride one paycheck at a time. That's what the original owner of this '68 Corvette had in mind.
He lived in Philadelphia and bought this Rally Red '68 Corvette with a 427 Tri-Carb and four-speed. He drove it in stock trim while he was making payments, then after that last one was mailed off, he ordered a load of equipment from Motion.
"He always loved the Motion cars," said current owner Jamie Jarvis of Jonesboro, Arkansas, "but he was just a working guy, so he ordered the conversion kit from Motion and had it installed at a shop there in Philadelphia to convert the car to a Phase III. That was in 1973."
Wheels: Many Motion cars were equipped with Ansen wheels.
For the next three years, owner No. 1 enjoyed driving and racing a very hot Corvette. In 1976, he sold it to the second owner with 32,000 miles on it. Owner No. 2 racked up only 4,000 miles on it over the next two years, and in 1978, he parked it in his driveway. The engine and transmission were removed and placed on the driveway next to the car, and there it sat for the next 25 years until 2003.
Those 25 years of exposure to sun, rain, and snow didn't do anything to improve its condition. Jamie found it one day while surfing for Corvettes on eBay. "When I got the car it had no paint on it, and the motor and transmission were sitting next to the car. It was in really bad shape and had been banged up in several spots," Jamie recalls. "But it was amazingly complete. It still had all of the Motion pieces with it. It was all in rough shape but they were all there." Jamie thinks most of his Motion-enthusiast friends must have been lying low that week because he was able to buy the car pretty reasonably.
Look Out: The Phase III moniker is really just giving everyone a fair warning.
Once Jamie got the car home, he went to work on it right away, working on it after work and on weekends. Because it was complete, he didn't have to do a lot of searching for parts, but one original item that did have to be replaced was an Ansen Sprint front wheel. Years earlier, a previous owner had an encounter with a curb and came out on the losing end. Pieces of the broken wheel were still in the rear of the car.
As the restoration took place, Jamie began trying to get in touch with the original owner. The guy he bought it from had a vague recollection of his name and address, and a call to directory assistance jogged his memory. Jamie called that number and was referred to the guy's nephew. The nephew turned out to be the original owner and was beside himself to learn that his car had survived and was being restored. He had some great tales to tell about its speed and power. He said it was never beat in a street race. A cousin went so far as to buy a '70 Hemi 'Cuda to beat the Corvette. He could not beat it and ended up selling the Hemi 'Cuda to Ronnie Sox. He also said he threw the original Tri-Carb away because he could not get it tuned. he had some old photos of the car's early days, including its conversion, and he promised to try and recover them from storage. In the meantime, he was helpful in answering questions about some of the restoration details.