Our seats were worn and needed...
Our seats were worn and needed new covers. Mid America Motorworks has anextensive line of interior seat covers and makes its products on-site toensure high quality.
While it may not be apparent when you're enjoying driving your Corvette,the seat you're sitting in will wear out with time. Just like balljoints and tires, seats see a lot of wear and tear over the years andare one of the few parts that age even when the car is not in use.Especially on hot, sunny days (or frosty cold nights, for that matter),seat surfaces are exposed to a lot of direct sunlight, which causes themto fade and crack. Seating surfaces often need to be replaced,especially the leather-clad seats in C3 ('68-'82) Corvettes.
Our '69Corvette convertible's seats were well worn like the rest of the car. Acall to Mid America Motorworks resulted in a new set of leather seatcovers. Mid America offers a complete line of interior parts for anyyear Corvette. With a factory on its property creating these slip-oncovers, it doesn't take much to install a set at home.
The procedureinvolves only a few tools and some patience working the cover intoplace. You'll spend more time repairing (or replacing) the original seatframe, especially if you've carried any heavier occupants in the recentpast.
We utilized the services of The Last Detail to install the covers.The results were a terrific pair of new seat covers that clearlycomplement the looks and seating comfort of the new interior.
 Step one was to remove the...  Step one was to remove the seats from the car, then remove the coversand foam cushions. With the soft parts removed, it was easy to see ourseatbacks were also worn. We repaired the broken springs and repaintedthe back with rust inhibiting black paint. |  These clips help hold the...  These clips help hold the seat covering in place. You'll need a largenumber of clips, so make sure you're well stocked before you begin. |  The clips attach the covering...  The clips attach the covering to the seat frame. Before you move to thisstage, make sure the cover has been stretched and pulled into position.If the seat foam is in poor shape, replace it. |
 Wrestling with the seat cover...  Wrestling with the seat cover material can be a two-person job. The keyis to pull it tight and work the material into position. Depending onthe year of your car, there may be center seating-frame connections, sofollow the directions supplied with the seats. |  The final touch is installing...  The final touch is installing the seatback. The cover should fit intothe frame and cover the edges of the seat cover. |  The final look of the cover...  The final look of the cover in place is considerably better than theoriginal. Mid America Motorworks offers high-quality covers that fitright the first time. |