Corvette Fever Homepage Corvette Fever
Facebook Click here to find out more!

Project Shark Attack 5 Speed Swap Transmission Tunnel

Prev  Next
 
Project Shark Attack 5 Speed Swap Transmission Tunnel
Project Shark Attack 5 Speed Swap Transmission Tunnel
9 With the transmission in proper position, we can see the rear of the tranny is down to clear the top of the tunnel. In most installs, the driveshaft angle needs to be modified to allow the correct three-degree driveshaft angle. We go back to the differential and install a 31/416-11/44-inch-thick washer between the differential front mount cushion and the front differential mount bracket to lower the front of the differential. Routing the O/D speedo cable in the original position can cause cable bind, so we ran the speedo cable through the firewall where an automatic transmission cable would be. We then followed an automatic transmissions speedo cable routing. View Related Article
Project Shark Attack 5 Speed Swap Keisler TKO 5 Speed Project Shark Attack 5 Speed Swap Driveshaft Project Shark Attack 5 Speed Swap Cleaning The Flywheel Surface Project Shark Attack 5 Speed Swap Installed Clutch Project Shark Attack 5 Speed Swap Transmission Input Housing Project Shark Attack 5 Speed Swap Location Dowels Project Shark Attack 5 Speed Swap Installing The 5 Speed
Project Shark Attack 5 Speed Swap Lowering In As One Piece Project Shark Attack 5 Speed Swap Mount Plate Adapter Project Shark Attack 5 Speed Swap Transmission Tunnel Project Shark Attack 5 Speed Swap Yoke Project Shark Attack 5 Speed Swap New Keisler Quiet Shifter Project Shark Attack 5 Speed Swap Shifter In Place Project Shark Attack 5 Speed Swap Tightening The Retaining Straps
Project Shark Attack 5 Speed Swap Shifter In Stock Location
Trade In Value