Corvette Fever Homepage Corvette Fever

1958 Chevrolet Corvette Knuckle

Prev Next
<b>4.</b> (next two photos) The bearing between the spindle and knuckle is installed withthe lip facing the knuckle, and then the kingpin is slid into place fromthe bottom. Be careful. The groove for centering the kingpin is not atan equal distance from the ends. The longer side should go to the bottomset of spindle bearings. There are shims supplied with the kit ifnecessary; our set did not require any.
Simplify Your Steering: Bushings to Bearings

 4. (next two photos) The bearing between the spindle and knuckle is installed withthe lip facing the knuckle, and then the kingpin is slid into place fromthe bottom. Be careful. The groove for centering the kingpin is not atan equal distance from the ends. The longer side should go to the bottomset of spindle bearings. There are shims supplied with the kit ifnecessary; our set did not require any.  View Related Article

 

Get Adobe Flash player

Car Research Guide
Source Interlink Media © 2008 Corvette Fever,
Source Interlink Media
All rights reserved. WEB-058