How do you improve on perfection? Like most things, there is always room for improvement, and Corvettes are no exception. For Corvette fans, there are some things C4s and C5s can do much better than sharks ('68-'82). Luckily, the folks at Stainless Steel Brakes Corporation have a solution for the braking blues.
If you've been paying close attention, you've witnessed a number of upgrades to our '72 Corvette. Thus far, we've converted our differential to 3.73:1 gears, installed a rack-and-pinion steering kit, offset trailing arms, and a complete Vette Brakes & Products rear suspension and traverse spring front suspension.
Now it's time to turn our attention to the braking system. After lots of research, we selected the Stainless Steel Brakes Force 10 system. In addition to the SSBC parts, Classic Tube supplied the brake lines.
Our install hit a few snags along the way due to previous modifications. If you remember from an earlier article, we installed offset trailing arms from Van Steel. At that time, Van Steel required we supply the old trailing arms to utilize the spindles for the offset trailing arms. The company also needed the front hubs plus all four disc-brake rotors from SSBC to set them up for correct runout. SSBC did us a favor by shipping the rotors, while we shipped the front hubs and trailing arms to Van Steel for this procedure.
Follow along as we guide you through the installation of these parts and improve our shark's stopping power.
Here's our new brake-line kit waiting to be installed. We removed theold lines, saving the
Regardless of what everyone says, it is possible to install new brakelines without removin
Next, we located the two master-cylinder lines and fitted them betweenthe master cylinder
We started with the front brakes by installing the slotted rotors,aligning the mark on the