Corvette Fever Homepage Corvette Fever
Facebook Click here to find out more!

L98 Tuned Port Intake Egr Valve Fuel Injector In Place

Prev  Next
 
L98 Tuned Port Intake Egr Valve Fuel Injector In Place
L98 Tuned Port Intake Egr Valve Fuel Injector In Place
Now the EGR valve and fuel-injector rails can go back in place. Tighten the EGR valve but don't put in the bolts for the injector rails since you'll need to move them around a little to get the runners back into place. Also, using a little bit of lubricant such as oil or transmission assembly lube will help the O-rings slide into place without damage. View Related Article
L98 Tuned Port Intake Intake L98 Tuned Port Intake Remove Plenum From Runners L98 Tuned Port Intake Remove Distributor L98 Tuned Port Intake Disconnect Fuel Lines To Injector Rails L98 Tuned Port Intake Remove Runners L98 Tuned Port Intake 40 Torx Head Bolts Removed L98 Tuned Port Intake Cold Start Injector
L98 Tuned Port Intake Remove Fuel Injector L98 Tuned Port Intake Check Egr Valve L98 Tuned Port Intake Clean Up Any Coolant L98 Tuned Port Intake Intake Bolts T45 Remove L98 Tuned Port Intake Clean Shop Rags Under Intake Runners L98 Tuned Port Intake Tap All Hols L98 Tuned Port Intake Clean Sealing Surfaces
L98 Tuned Port Intake Fel Pro Gaskets L98 Tuned Port Intake Reinstall Intake Bolts L98 Tuned Port Intake Egr Valve Fuel Injector In Place L98 Tuned Port Intake Runners Slid In Place L98 Tuned Port Intake Different Sizes Of Bolts For Intake L98 Tuned Port Intake Connect Vaccum L98 Tuned Port Intake Distributor Back In Place
L98 Tuned Port Intake Plenum Reinstalled On Runners L98 Tuned Port Intake Intalling Ac Compressor And Belt L98 Tuned Port Intake Gasket Sealer On Coolant Lines L98 Tuned Port Intake Start Engine And Timing L98 Tuned Port Intake Cleaning Throttle Body L98 Tuned Port Intake Adding Coolant
Trade In Value