Slip the new glovebox cover on the front end of the outer lid, and proceed to work it on from the front, sides, and rear. Be forewarned: this takes some doing as you have to stretch the material quite a bit; be sure the holes in the new cover are oriented in the correct position with the screw retainers in the lid. A hairdryer will soften the cover material somewhat and make it more pliable, which will help in stretching it to get it to fit. Once it is on completely, replace the inner lid, insert and tighten the five screws removed previously, and reattach the latch and tighten the two screws that retain it. Put the lid back in position in the car and fasten it to the hinge with the four screws you initially removed at the beginning of this project.