C6 Corvette Exhaust Install - Pump Up the Volume

Now remove the H-pipe and set it out of the way. You'll re-use it.

The rear hangers (one per muffler) ride in rubber grommets. Use a water-based lubricant (soap and water, or Windex) to facilitate sliding the hangers out of their rubber grommets.

Wiggle the mufflers and over-the-axle pipes out of the car.

You now reverse the OE exhaust removal steps. As you tighten the catalytic converter flanges, check for clearance between the pipes and the framerails.

Snug up the 13mm spring hanger bolts.

A new set of Corsa axle-back exhausts, which consist of a set of the Sport mufflers, polished tips, and over-the-axle pipes.

Insert the over-the-axle pipes.

Slide the over-the-axle pipe into the factory H-pipe on the passenger side and tighten the clamp. Just snug the clamps but don't tighten them. Do the same to the driver's side.